Silverado 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
Backup Lamp Switch: Service and Repair
NV 4500
Backup Lamp Switch Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle.
2. Disconnect the backup lamp switch electrical connector (1).
3. Remove the backup lamp switch and seal.
Installation Procedure
1. Ensure the seal is installed on the switch.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the backup lamp switch.
^
Tighten the switch to 28 Nm (21 ft. lbs.).