Silverado 1500 4WD V8-6.0L (2010)
Brake Rotor/Disc: Service and Repair
Rear Brake Rotor Replacement (JH7)
Rear Brake Rotor Replacement (JH7)
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
1. Release the park brake.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
4. Remove the hub and rotor assembly. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement (See: Transmission and Drivetrain/Drive
Axles, Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement).
5. Mark the relationship of the hub to the rotor.
6. Place the hub and rotor assembly on a hydraulic press.
7. Press the wheel studs out of the hub and rotor assembly.
8. Separate the hub from the rotor.
Installation Procedure
1. Align the hub and the rotor.
2. Install each of the new wheel studs into the hub and rotor assembly by performing the following:
1. Install the stud.
2. Install 4 washers to the stud.
