Silverado 1500 4WD V8-6.0L (2010)
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the lower shock absorber nut and bolt.
*
Tighten the upper shock absorber bolts to 115 Nm (85 lb ft).
*
Tighten the lower shock absorber bolts to 115 Nm (85 lb ft).
4. Remove the support from the rear axle.
5. Remove the safety stands.
6. Lower the vehicle.
Shock Absorber Disposal
Shock Absorber Disposal
Warning
Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap ring is removed, the
contents of the shock absorber will come out with extreme force which may result in personal injury.
Warning
To prevent personal injury, wear safety glasses when centerpunching and drilling the shock absorber. Use care not to puncture the shock absorber tube
with the centerpunch.
