Silverado 1500 4WD V8-6.0L (2010)
4. Install the selective shim (1) on the shoulder on the differential pinion gear (2).
Note: Press the bearing on until the cone seats on the pinion shim.
5. Using the J 22828 - installer or the J 36614 - installer , install the inner pinion bearing.
6. Install a new collapsible spacer.
7. Lubricate the pinion bearings with axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations (USA and Canada) (See:
Maintenance).
8. Install the outer pinion bearing into the axle housing.
9. Install the differential pinion gear into the axle housing.
Note: DO NOT re-use the old pinion nut, replace with NEW only.
10. Install the NEW differential pinion oil seal, flange/yoke, and the NEW nut and washer. Refer to Drive Pinion Flange/Yoke and/or Oil Seal
Replacement (See: Pinion Flange/Service and Repair/Rear Drive Axle).
