Silverado 1500 4WD V8-6.0L (2010)
3. Align the reference marks on the transmission or the transfer case (1), output shaft yoke (2), and the propeller shaft (6).
Note: When installing the propeller shaft bolts, hand tighten the bolts. DO NOT tighten them to specification until the center bearing support
bolts have been installed and torqued to specifications.
4. Install the propeller shaft (2), the straps (3), the propeller shaft bolts (3) on the transmission or the transfer case (1).
5. Position the center support bearing (1) on the frame.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the center bearing support nuts.
Tighten the center support bearing nuts to 40 Nm (30 lb ft).
