Silverado 1500 4WD V8-6.0L Hybrid (2009)
Note
When installing the regulator (2) align the gear to the motor drivegear before installing the screw.
3. Install the regulator (2) to the motor/module.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution) .
4. Install the screw (1) to the motor/module.
Tighten nuts to 5 Nm (44 lb in).
Note
When removing the tension from the cables, depress and hold spring on the regulator to remove tension from the cable before locking the pulley into the
frame. Once the pulley has been locked, the spring can then be release.
5. Install the rear sliding window pulley (1).
