Silverado 1500 4WD V8-6.0L Hybrid (2009)
‹› If not the specified value, test the serial data circuit for a short to ground, refer to Testing the Serial Data Circuits for a Short to ground.
6. Disconnect the harness connector at the JX 221 splice pack.
7. Test for less than 2 ohm between the serial data circuit terminal 1 and the JX 221 splice pack terminal D.
‹› If greater than the specified range, test the serial data circuit for an open/high resistance. If the circuits test normal, replace the splice pack.
Testing the Serial Data Circuits for a Short to Voltage
1. Ignition OFF, disconnect the harness connectors at the JX 221, JX 339, and JX 223 splice packs, as equipped.
2. Ignition ON, test for less than 4.5 V between the DLC serial data circuit terminal 1 and ground.
‹› If greater than the specified range, repair the short to voltage.
3. Test for less than 4.5 V between each serial data circuit and ground.
‹› If greater than the specified range, perform the appropriate test listed below:
*
Serial data circuits with one control module, test the serial data circuit for a short to voltage. If the circuit tests normal replace the control
module.
*
Serial data circuits with 2 or more control modules, test each section of the serial data circuit for a short to voltage. If the circuits test normal,
replace the control module that causes the short to voltage when connected.
Testing the Serial Data Circuits for a Short to Ground
1. Ignition OFF, disconnect the harness connectors at the JX 221, JX 339, and JX 223 splice packs, as equipped.
2. Test for infinite resistance between the DLC serial data circuit terminal 1 and ground.
‹› If not the specified value, repair the short to ground.
3. Ignition OFF for 60 seconds, test for greater than 100 ohm between each serial data circuit and ground.
‹› If less than the specified range, perform the appropriate test listed below:
*
Serial data circuits with one control module, test the serial data circuit for a short to ground. If the circuit tests normal replace the control
module.
*
Serial data circuits with 2 or more control modules, test each section of the serial data circuit for a short to ground. If the circuits test normal,
replace the control module that causes the short to ground when connected.
Testing the Serial Data Circuit for an Open/High Resistance
1. If equipped with a JX 339 splice pack, ignition ON, verify the scan tool communicates with one or more control modules connected to the JX 339
splice pack.
‹› If all control modules on the JX 339 spice pack do not communicate, test the serial data circuit between the JX 221 and JX 339 splice packs
for an open/high resistance. If the circuit tests normal, test each splice pack for an open/high resistance.
2. Ignition OFF, disconnect one of the harness connectors listed below:
*
JX 221 if the control modules not communicating are connected to the JX 221 splice pack
*
JX 223 if the control modules not communicating are connected to the JX 223 splice pack, if equipped
*
JX 339 if the control modules not communicating are connected to the JX 339 splice pack
3. Install a 3A fused jumper wire between the disconnected splice pack connector terminal listed below and a low speed GMLAN serial data circuit
that is not communicating:
*
JX 221 terminal D
*
JX 223 terminal A
*
JX 339 terminal A
4. Ignition ON, verify the scan tool communicates with the control modules connected to the low speed GMLAN serial data circuit.
‹› If any control module does not communicate, test each section of the serial data circuit for an open/high resistance. If the circuits test normal,
replace the control module that does not communicate when connected.
Repair Instructions
Perform theDiagnostic Repair Verification (See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
