Silverado 1500 4WD V8-6.0L Hybrid (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
Crankshaft Position Sensor Replacement
Removal Procedure
Note
Perform theCrankshaft Position System Variation Learn (See: ) whenever the crankshaft position sensor is removed or replaced.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Reposition the engine wiring harness sleeve (2).
3. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
4. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
5. Remove the CKP sensor bolt.
6. Remove the CKP sensor.
Installation Procedure