Silverado 1500 4WD V8-6.2L (2010)
Removal Procedure
1. Release the park brake.
2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Procedures/Parking Brake Cable
Adjuster Disabling).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Disconnect the front park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front
to intermediate park brake cable connector.
5. Disconnect the left park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front
to intermediate park brake cable connector.
6. Remove the intermediate park brake cable.
Installation Procedure