Silverado 1500 4WD V8-6.2L (2010)
2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Procedures/Parking Brake Cable
Adjuster Disabling).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Disconnect the right park brake cable (1) from the intermediate cable equalizer bar (2).
5. Release the right park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit (3) rearward.
6. Release the park brake cable (1) from the rear axle housing cover clip.
7. Remove the park brake cable clip bolt (2).
8. Release the park brake cable from the rear axle bracket by compressing the locking tabs and pulling the park brake cable conduit (1) rearward.
9. Disconnect the park brake cable eye (2) from the park brake actuator lever.
10. Remove the park brake cable assembly from the vehicle.
Installation Procedure