Silverado 1500 4WD V8-6.2L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the engine mount to engine bolts (1).
Tighten the bolts to 50 Nm (37 lb ft).
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block.
5. Install the left side exhaust manifold heatshield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side (V6) (See: Exhaust System/Heat
Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left Side)Exhaust Manifold Heat Shield Replacement - Left Side (V8) (
See: Exhaust System/Heat Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left Side).
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 Nm (48 lb ft) starting with the middle bolt then either side bolt.
