Silverado 1500 4WD V8-6.2L (2010)
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block lifting tab (1).
5. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 Nm (48 lb ft) starting with the middle bolt then either side bolt.
6. Install the starter motor. Refer to Starter Replacement (V8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter
Replacement (V6) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter Replacement (6.6L) (See: Starting and
Charging/Starting System/Starter Motor/Service and Repair).
