Silverado 1500 4WD V8-6.2L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the evaporator tube nut to the condenser and tighten to 16 Nm (12 lb ft).
3. Connect the evaporator tube to the auxiliary A/C tube using new sealing washers, if equipped. Refer to Air Conditioning System Seal Replacement
(See: Coupler HVAC/A/C Coupler O-ring/Service and Repair/Air Conditioning System Seal Replacement).
4. Install the evaporator tube nut to the auxiliary A/C tube, if equipped, and tighten to 16 Nm (12 lb ft).
5. Install the evaporator tube to the evaporator.
6. Install the evaporator tube nut to the evaporator and tighten to 16 Nm (12 lb ft).
7. Install the surge tank hold down nut and bolt and position aside.
8. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine
Performance Checks/Air Cleaner Housing/Service and Repair).
9. Install the upper radiator air baffle and deflector. Refer to Radiator Air Upper Baffle and Deflector Replacement (See: Engine, Cooling and
Exhaust/Cooling System/Radiator/Service and Repair/Removal and Replacement/Radiator Air Upper Baffle and Deflector Replacement).
10. Evacuate and recharge the system. Refer to Refrigerant Recovery and Recharging (Non-HP2) (See: Refrigerant/Service and Repair)Refrigerant
Recovery and Recharging (HP2) (See: Service and Repair).
11. Leak test the fittings of the components using the J 39400-A .
