Silverado 1500 4WD V8-6.2L (2010)
3. Remove the ground strap nut from the stud at the front of dash.
4. Remove the ground strap from the stud.
Installation Procedure
1. Install the ground strap to the stud.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the ground strap nut to the stud at the front of dash and tighten to 9 Nm (80 lb in).
3. Position the ground strap and engine wiring harness ground.
4. Install the engine wiring harness ground bolt tighten to 16 Nm (12 lb ft).
Battery Negative Cable Disconnection and CONNECTION
Battery Negative Cable Disconnection and Connection
Disconnect Procedure
Warning: Refer to Battery Disconnect Warning (See: Service Precautions).
Note: Do NOT disconnect the negative battery cable from the battery until a period of at least 1 minute after performing the following: Turning the
ignition to OFF, without pausing at ACCESSORY, and without applying the brake pedal. These steps are necessary to allow the brake system pressure
relief procedure to occur. Failure to follow these steps may result in warning lamps and/or DTCs being set pertaining to interruption of the pressure relief
procedure. Other vehicle systems may also be affected by not allowing a 1 minute duration for power-down.
