Silverado 1500 4WD V8-6.2L (2010)
3. Reverse the CH-49240-2 (3).
4. Using the CH 41805 - kit (2), CH-49240-3 (1), CH-49240-1 (4) and the CH-49240-2 (2), collapse the edge of the ball joint to create the lock tabs
(5). Tighten the CH-49240-3 to 250 Nm (184 lb ft).
Note: Repeat step 4 to ensure that all of the lock tabs are of the same depth and size.
5. Rotate the CH 41805 - kit (2) 180 degrees and repeat the process.
6. Install the wheel drive shaft, if needed. Refer to Wheel Drive Shaft Replacement (2500) (See: Transmission and Drivetrain/Drive Axles, Bearings
and Joints/Axle Shaft Assembly/Service and Repair)Wheel Drive Shaft Replacement (1500) (See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair).
7. Install the steering knuckle in the vehicle. Refer to Steering Knuckle Replacement (See: Rear Knuckle/Service and Repair).
8. Install the lower ball joint stud nut and tighten to:
*
First Pass 50 Nm (37 lb ft)
*
Final Pass additional 95 degrees
9. Remove the supports and lower the vehicle.