Silverado 1500 4WD V8-6.2L (2010)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement (JD9, JF3, JF7, JG4) (See: Brakes and Traction Control/Disc Brake
System/Brake Rotor/Disc/Service and Repair/Front Brake Rotor Replacement (JD9, JF3, JF7, JG4))Front Brake Rotor Replacement (JH6, JH7) (
See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Front Brake Rotor Replacement (JH6, JH7)).
4. Use the J 43631 to press the stud from the wheel bearing/hub.
Installation Procedure
1. Install a new stud. Use washers and a wheel nut and pull the new stud into the hub.
2. Install the brake rotor. Refer to Front Brake Rotor Replacement (JD9, JF3, JF7, JG4) (See: Brakes and Traction Control/Disc Brake
System/Brake Rotor/Disc/Service and Repair/Front Brake Rotor Replacement (JD9, JF3, JF7, JG4))Front Brake Rotor Replacement (JH6, JH7) (
See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Front Brake Rotor Replacement (JH6, JH7)).
3. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
4. Lower the vehicle.