Silverado 1500 4WD V8-6.2L (2010)
Band Apply Servo: Service and Repair
2-4 Servo
Special Tools
J 29714-A Servo Cover Depressor
Removal Procedure
1. Remove the catalytic converter pipe. Refer to Catalytic Converter Replacement (LY6 with Exhaust Flange) (See: Engine, Cooling and
Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement (L9H with Exhaust Flange) (See: Engine,
Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement (Gen IV Engines with Exhaust
Clamp) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement (LFA with
Exhaust Clamp) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement
(LMM) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair).
2. Remove the heat shield bolts.
3. Remove the heat shield.
4. Support the transmission.
5. Remove the transmission crossmember. Refer to Transmission Support Crossmember Replacement (2WD 1500/2500) (See: Body and
Frame/Frame/Cross-Member/Service and Repair)Transmission Support Crossmember Replacement (4WD 1500/2500) (See: Body and
Frame/Frame/Cross-Member/Service and Repair)Transmission Support Crossmember Replacement (2WD 2500 HD/3500) (See: Body and
Frame/Frame/Cross-Member/Service and Repair)Transmission Support Crossmember Replacement (4WD 2500 HD/3500) (See: Body and
Frame/Frame/Cross-Member/Service and Repair).
6. Lower the transmission with a suitable jack.
7. Remove the oil pan bolt below the servo.
8. Install the J 29714-A .
9. Tighten the bolt on J 29714-A in order to compress the servo cover.
