Silverado 1500 4WD V8-6.2L (2010)
7. Tighten the propeller shaft bolts (3) to specifications.
Tighten the propeller shaft bolts to 25 Nm (18 lb ft).
8. Install the boot (3) and the new clamps (2) onto the front propeller shaft slip yoke (4).
Note: Ensure that the master splines on the slip yoke and the stub shaft are aligned before installing the rear propeller shaft.
9. Apply a small amount of clean chassis grease to the slip yoke and the rear propeller shaft.
10. Install the rear portion of the propeller into the front portion of the propeller shaft.
