Silverado 1500 4WD V8-6.2L (2010)
1. Install the control rod onto the control lever first.
2. Slide the control rod forward.
3. Install the control rod onto the shift control lever.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the control rod adjusting bolt.
Tighten the bolt to 15 Nm (11 lb ft).
5. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement).
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement (See: Service and Repair/Removal and Replacement/BW
4485-NR3 - Transfer Case/Transfer Case Shield Replacement).
