Silverado 2500 2WD V8-6.0L VIN U (2004)
10. Reposition the inlet hose clamp at the water pump.
11. Remove the inlet hose from the water pump.
Installation Procedure
1. Install the inlet hose to the water pump.
2. Position the inlet hose clamp at the water pump.
3. Install the inlet hose to the radiator.
4. Position the inlet hose clamp at the radiator.
5. Install the inlet hose clip to the fan shroud.
6. Install the radiator vent inlet hose to the radiator inlet hose clips.
7. If necessary, install the engine sight shield.
