Silverado 2500 2WD V8-8.1L VIN G (2005)
Camshaft: Service and Repair
Camshaft Replacement
Removal Procedure
1. Remove the grille.
2. Remove the Air Conditioning (A/C) condenser.
3. Remove the valve lifters.
4. Remove the timing chain and sprocket.
5. Remove the camshaft retainer bolts.
6. Remove the camshaft retainer.
7. Install three 8 - 1.25 x 100 mm bolts into the camshaft front bolt holes.
8. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
9. Remove the bolts from the front of the camshaft.
10. Clean and inspect the camshaft.
Installation Procedure
1. Apply lubricant GM P/N 12345501 (Canadian P/N 992704), or equivalent to the following components:
^
The camshaft lobes
^
The camshaft bearing journals
^
The camshaft bearings
Notice: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the
camshaft bearings.
