Silverado 2500 2WD V8-8.1L VIN G (2005)
Power Steering Line/Hose: Service and Repair
Power Steering Cooler Pipe/Hose Replacement (Without Hydroboost)
Power Steering Cooler Pipe/Hose Replacement (Without Hydroboost)
Removal Procedure
1. Remove the front grille.
2. Remove the clamp retaining the power steering outlet hose (3) from the power steering gear (4).
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
3. Remove the clamp retaining the power steering inlet hose from the power steering pump (5).
4. Remove the bolts (2) retaining the power steering cooler from the radiator support.
5. Remove the power steering cooler from the vehicle.
Installation Procedure
1. Install the power steering cooler (1) to the vehicle.
^
Tighten the power steering cooler retaining bolts to 5 Nm (44 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.