Silverado 2500 2WD V8-8.1L VIN G (2005)
Rear Wheel Steering Actuator: Service and Repair
Steering Gear Actuator Boot Shield Replacement
Steering Gear Actuator Boot Shield Replacement
Removal Procedure
1. Notice:
When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or
the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.
Raise the vehicle. Refer to Vehicle Lifting.
2. Unsnap the locking tabs on the rack and pinion boot protector (1).
3. Remove the rack and pinion boot protector (1) from the rack and pinion boot (2).
Installation Procedure
1. Install the rack and pinion boot protector (1) to the rack and pinion boot (2).