Silverado 2500 2WD V8-8.1L VIN G (2005)
2. Slide the installer tool over the turbine shaft and ground sleeve until the seal starts into the seal bore. Strike the installer tool with mallet (1) to
drive the seal into the seal bore. The seal is installed correctly when the shoulder of the installer tool squarely contacts the outer surface of the oil
pump.
3. Install the torque converter into the transmission.
Selector Shaft Seal Replacement
Selector Shaft Seal Replacement
^
Tools Required
-
J 43911 Selector Shaft Seal Remover
-
J 43909 Selector Shaft Seal Installer
Removal Procedure
1. Remove the Park/Neutral Position (PNP) Switch.
2. Be sure that the jackscrew for J 43911 is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool
is firmly attached to the seal shell.
4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure
