Silverado 2500 2WD V8-8.1L VIN G (2005)
6. Remove the 2 detent spring bolts (3). Remove the detent spring assembly (2).
7. Important: As the control valve assembly is removed, be careful not to lose the manual selector valve pin or allow the manual selector valve to
slide out of the control valve assembly.
Remove 11 bolts at locations marked (1) and 4 bolts at locations marked (2). Support the control valve assembly (about 10 pounds) and remove
the last bolt marked (1).
8. Lower the control valve assembly (1) to clear the dowel pins (2) in the main housing.
