Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Installation Procedure
1. Connect the rear side door cable. Ensure the cable is fully seated past the guide tab.
2. Slide the rear side door inside handle assembly into place (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the rear side door inside handle fasteners and tighten to 2 Nm (18 lb in).
4. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (SLT) (See: Rear Door Panel/Service and Repair/Rear Side Door
Trim Panel Replacement (SLT))Rear Side Door Trim Panel Replacement (YE9) (See: Rear Door Panel/Service and Repair/Rear Side Door Trim
Panel Replacement (YE9)).
