Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
9. Position the master cylinder (1) to the master cylinder adapter.
10. Install 2 new master cylinder nuts (1) and tighten to 33 Nm (24 lb ft).
11. Inspect the battery state of charge. Refer to Battery Inspection/Test (See: Starting and Charging/Testing and Inspection/Component Tests and
General Diagnostics).
12. If necessary, connect a battery charger to the 12V battery. Refer to Battery Charging (See: Starting and Charging/Battery/Service and
Repair/Procedures).
13. Install a scan tool to the vehicle.
Note: The ignition switch must remain in the ON position with the engine OFF during this procedure.
14. Turn the ignition ON with the engine OFF.
15. Using the scan tool, perform the following steps:
1. Select Diagnostics
2. Select the appropriate vehicle information
3. Select Chassis