Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
4. Install the coolant air bleed covers (313) and seals (308), if required.
5. Install the coolant air bleed cover bolts (312), if required.
Tighten the bolts to 12 Nm (106 lb in).
6. Install the radiator vent inlet hose (2) to the coolant air bleed pipe fitting.
7. Position the radiator vent inlet hose clamp (1) at the coolant air bleed pipe fitting.
8. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement ().
9. Fill the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill) (See: Service and Repair)Cooling System Draining and
Filling (Static Fill) (See: Service and Repair).
10. If the rear coolant air bleed covers were replaced, install the intake manifold. Refer to Intake Manifold Replacement (Without AFM) (See:
Engine/Intake Manifold/Service and Repair)Intake Manifold Replacement (With AFM) (See: Engine/Intake Manifold/Service and Repair).
