Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
8. Using J-26900-12 - indicator (1) and J-26900-13 - base (2), measure the camshaft end play.
*
The production value is 0.050-0.114 mm (0.002-0.0045 in) and service limit is 0.20 mm (0.008 in).
*
Replace the camshaft gear or the camshaft thrust plate if measured value exceeds service limit.
9. Remove the camshaft reluctor screws.
10. Remove the camshaft reluctor.
Warning
The two piece cam gear must be bolted together to prevent the spring tension from unloading upon removal. Additionally, the two piece cam gear must
remain bolted together until it is re-installed to the camshaft and fully engaged to the crankshaft gear. Failure to do so may result in personal injury.
11. Remove the camshaft exciter ring.
