Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
10. Ensure that the oil filter gasket is still on the old oil filter, if not remove the oil filter gasket from the adapter.
Installation Procedure
1. Apply clean engine oil to the NEW oil filter gasket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the NEW oil filter and tighten after contact plus 1 to 11/4 turn.
3. Tighten the oil pan drain plug to 84 Nm (62 lb ft).
4. Remove the oil drain pan from under the vehicle.
5. Lower the vehicle.
6. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities (See: Maintenance/Specifications) and Fluid and Lubricant
Recommendations (USA and Canada) (See: Maintenance).
7. Start the engine.
8. Inspect for oil leaks after engine start up.