Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
1. Install NEW center intake manifold gaskets.
2. Install the center intake manifold.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the center intake manifold bolts/nuts.
Tighten the bolts/nuts to 10 Nm (89 lb in).
4. Install the IAT sensor (2).
Tighten the sensor to 10 Nm (89 lb in).
5. Connect the IAT sensor electrical connector (1).
6. Install the turbocharger. Refer to Turbocharger Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Turbocharger/Service and Repair/Turbocharger Replacement).
