Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
9. Release the compressed air holding the valves in place.
10. Remove J 26999-20 (1) from the glow plug hole.
11. Continue to replace the valve stem seals on the remaining cylinders using the above procedures.
12. Install the glow plug. Refer to Glow Plug Replacement - Bank 1 (See: Powertrain Management/Glow Plug System/Glow Plug/Service and
Repair/Glow Plug Replacement - Bank 1) or Glow Plug Replacement - Bank 2 (See: Powertrain Management/Glow Plug System/Glow
Plug/Service and Repair/Glow Plug Replacement - Bank 2).
13. Install the valve rocker arm shaft, the valve bridges, and the push rods. Refer to Valve Rocker Arm, Shaft, and Push Rod Replacement (See:
Camshaft, Lifters and Push Rods/Rocker Arm Assembly/Service and Repair).
14. Install the upper and lower fan shroud. Refer to Engine Coolant Fan Lower Shroud Replacement (Mechanical) (See: Cooling System/Fan
Shroud/Service and Repair) and Engine Coolant Fan Upper Shroud Replacement (LMM Diesel) (See: Cooling System/Fan Shroud/Service and
Repair)Engine Coolant Fan Upper Shroud Replacement (Mechanical) (See: Cooling System/Fan Shroud/Service and Repair).
