Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
10. Disconnect the intake air heater electrical connector.
11. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
12. Remove the engine harness clip from the air inlet tube.
13. Remove the air inlet tube nuts and bolt.
14. Remove the air inlet tube.
15. Reposition the heater inlet hose clamp (1) at the exhaust gas recirculation (EGR) valve cooler.
16. Remove the heater inlet hose from the EGR valve cooler and reposition out of the way.
17. Remove the EGR valve cooler coolant hose clamp nut (2).
18. Reposition the EGR valve cooler coolant hose clamp (1).
19. Remove the EGR valve cooler coolant hose from the EGR valve cooler. Reposition the hose out of the way.
