Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Tighten the bolt to 25 Nm (18 lb ft).
3. Position the clip and install the fuel feed pipe nut (1).
Tighten the nut to 25 Nm (18 lb ft).
4. Install the fuel injection fuel feed manifold bolt (3).
Tighten the bolt to 25 Nm (18 lb ft).
3. Install a NEW EGR valve cooler gasket (1) onto the cooler studs, and install the EGR cooler (2) to the engine.
4. Install the EGR temperature sensors (3). Refer to Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1 (See: EGR
Temperature Sensor/Service and Repair/Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1) or Exhaust Gas
Recirculation Valve Temperature Sensor Replacement - Position 2 (See: EGR Temperature Sensor/Service and Repair/Exhaust Gas
Recirculation Valve Temperature Sensor Replacement - Position 2).
