Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
16. Install the air inlet tube and NEW gaskets.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution)
17. Install the air inlet tube nuts and bolt.
Tighten the nuts to 25 Nm (18 lb ft).
18. Connect the intake air heater electrical connector.
19. Connect the MAP sensor electrical connector.
20. Install the engine harness clip to the air inlet tube.
21. Install the air inlet tube to intake manifold tube bolt and nut.
Tighten the bolt/nut to 10 Nm (89 lb in).
