Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
2. Connect the water in fuel sensor wiring pigtail (2) to the engine wiring harness electrical connector.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Position the rear half of the wheelhouse liner (1) and install the rear bolts/retainers as required.
Tighten the bolts, if required to 2.5 Nm (22 lb in).
4. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
5. Start the engine. If the engine stalls, repeat the above step.
6. Once the engine starts, inspect for fuel leaks.
