Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the fuel injector bracket bolts.
Tighten the bolts to 30 Nm (22 lb ft).
6. Connect the engine wiring harness electrical connectors to the fuel injectors.
7. Install the left fuel injection fuel return pipe. Refer to Fuel Injection Fuel Return Pipe Replacement - Left Side (See: Fuel Return Line/Service
and Repair/Fuel Injection Fuel Return Pipe Replacement - Left Side).
8. Install the left fuel injection fuel feed pipes. Refer to Fuel Injection Fuel Feed Pipe Replacement - Left Side (See: Fuel Supply Line/Service and
Repair/Fuel Injection Fuel Feed/Fuel Injection Fuel Feed Pipe Replacement - Left Side).
9. If the fuel injectors were replaced, refer to Fuel Injector Flow Rate Programming (See: Procedures).
10. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
11. Start the engine. If the engine stalls, repeat the above step.
12. Once the engine starts, inspect for fuel leaks.
