Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
5. Position the wiring harness bracket (2) and install the bolts.
Tighten the bolts to 24 Nm (18 lb ft).
6. Connect the engine wiring harness electrical connector (1) to the fuel injection fuel rail fuel pressure sensor wiring harness extension.
7. Install the fuel injection fuel rail fuel pressure sensor wiring harness extension clip (3) to the wiring harness bracket.
8. Install the turbocharger coolant outlet pipe. Refer to Turbocharger Coolant Hoses/Pipes Replacement (LMM Outlet Pipe) (See:
Turbocharger/Turbocharger Coolant Line/Service and Repair).
9. Install the fuel filter assembly. Refer to Fuel Filter Assembly Replacement (See: Fuel Filter/Service and Repair/Fuel Filter Assembly
Replacement).
10. Install the heater outlet pipe. Refer to Heater Outlet Hose Replacement (Non-HP2) (See: Engine, Cooling and Exhaust/Cooling System/Heater
Hose/Service and Repair).
11. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
12. Start the engine. If the engine stalls, repeat the above step.
13. Once the engine starts, inspect for fuel leaks.
