Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the fuel rail fuel feed pipe upper clamps and bolts (2 and 3).
Tighten the bolts to 24 Nm (18 lb ft).
3. Tighten the fuel rail fuel feed pipe fitting (4) at the right fuel rail.
Tighten the fitting to 41 Nm (30 lb ft).
4. Tighten the fuel rail fuel feed pipe fitting (1) at the left fuel rail.
Tighten the fitting to 41 Nm (30 lb ft).
5. Install the EGR valve cooler. Refer to Exhaust Gas Recirculation Valve Cooler Replacement (See: Emission Control Systems/Exhaust Gas
Recirculation/EGR Cooler/Service and Repair/Exhaust Gas Recirculation Valve Cooler Replacement).
6. Install the fuel feed pipe. Refer to Fuel Feed Pipe Replacement ().
7. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
8. Start the engine. If the engine stalls, repeat the above step.
9. Once the engine starts, inspect for fuel leaks.
Fuel Injection Fuel Feed Manifold Replacement
Fuel Injection Fuel Feed Manifold Replacement
Removal Procedure
