Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
4. Position the glow plug control module onto the bracket and install the bolts.
Tighten the bolts to 10 Nm (89 lb in).
5. Connect the engine wiring harness electrical connector (2) to the glow plug control module.
6. Connect the positive battery cable (1) to the glow plug control module.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: Starting and
Charging/Battery/Battery Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Dual Batteries) (See:
Starting and Charging/Battery/Battery Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Auxiliary
Battery) (See: Starting and Charging/Battery/Battery Cable/Negative/Service and Repair).
8. If a NEW glow plug control module was installed, program the module. Refer to Control Module References (See: Testing and
Inspection/Programming and Relearning).
