Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
1. Obtain a new SS 2 (1), SS 3 (4), TCC PCS (7), or modulated main pressure solenoid. Install O-rings (2 and 3) and lubricate with clean
transmission fluid. Push the new solenoid into the control valve assembly (5) with the wiring harness connector in the correct position.
2. Install the solenoid retainer (6). Connect the internal wiring harness to the solenoids replaced.
3. For a new TCC PCS (7), install O-rings and lubricate with clean transmission fluid. Push the new TCC PCS (7) into the control valve assembly
with the wiring harness connector in the correct position.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the TCC PCS retainer and bolt.
Tighten the bolt to 12 Nm (108 lb in).
