Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
1. Clean the mating surfaces on the air intake pipe and the turbocharger.
2. Align the arrow (2) on the air intake pipe to the arrow (1) on the turbocharger.
3. Install the air intake pipe (2) into the turbocharger.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: The clamp for the air intake pipe uses reverse threads.
4. Tighten the air intake pipe to turbocharger clamp (1).
Tighten the clamp to 4.6 Nm (41 lb in).
