Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Intake Air Temperature Sensor: Service and Repair
Intake Air Temperature (IAT) Sensor 2 Replacement
Intake Air Temperature (IAT) Sensor 2 Replacement
Removal Procedure
1. Remove the air intake pipe. Refer to Air Intake Pipe Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Intake Pipe Replacement).
2. Disconnect the engine wiring harness electrical connector (1) from the intake air temperature (IAT) sensor pigtail.
3. Remove the IAT sensor (2) from the center intake manifold.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
