Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
1. Install the IAT sensor (2) to the center intake manifold.
Tighten the sensor to 25 Nm (18 lb ft).
2. Connect the engine wiring harness electrical connector (1) to the IAT sensor pigtail.
3. Install the air intake pipe. Refer to Air Intake Pipe Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Intake Pipe Replacement).
