Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Installation Procedure
1. Install the negative battery cable to the vehicle.
2. Raise the vehicle.
3. Position the negative battery cable (2) to the engine block and position the engine wiring harness ground (4) on top of the negative battery cable
terminal.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the engine wiring harness ground bolt (3) and tighten to 25 Nm (18 lb ft).
5. Lower the vehicle.
6. Install the negative battery cable clip (1) to the positive and negative cable bracket.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: )Battery Negative
Cable Disconnection and Connection (Dual Batteries) (See: )Battery Negative Cable Disconnection and Connection (Auxiliary Battery) (See: ).
