Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
8. Install the oil level indicator tube bracket (2).
9. Install the oil level indicator tube bracket bolts (1).
Tighten the bolts to 21 Nm (15 lb ft).
10. Install the oil level indicator tube bolt (3).
Tighten the bolts to 21 Nm (15 lb ft).
11. Install the engine wiring harness clip to the oil level indicator tube bracket (2).
12. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts,
Brackets and Accessories/Drive Belt Tensioner/Service and Repair).
13. Install the generator. Refer to Generator Replacement (V6) (See: )Generator Replacement (V8) (See: )Generator Replacement (6.6L) (See: ).
14. Install the intake air heater. Refer to Intake Air Heater Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Intake Air
Heater/Service and Repair).
15. Install the fan assembly. Refer to Fan Replacement (Mechanical) (See: Engine, Cooling and Exhaust/Cooling System/Radiator Cooling
Fan/Service and Repair)Fan Replacement (Diesel) (See: Engine, Cooling and Exhaust/Cooling System/Radiator Cooling Fan/Service and Repair
).
16. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: Battery/Battery
Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Dual Batteries) (See: Battery/Battery
Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Auxiliary Battery) (See: Battery/Battery
Cable/Negative/Service and Repair).
Generator Bracket Replacement (V8)
Generator Bracket Replacement (V8)
Removal Procedure
