Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
3. Install the engine wiring harness terminal (2) to the generator.
4. Install the engine wiring harness nut (3).
Tighten the nut to 9 Nm (80 lb in).
5. Position the engine wiring harness boot (4) in order to cover the terminal stud.
6. Connect the engine wiring harness electrical connector (1) to the generator.
7. Install the drive belt. Refer to Drive Belt Replacement (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and
Accessories/Drive Belt/Service and Repair).
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: Battery/Battery
Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Dual Batteries) (See: Battery/Battery
Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (Auxiliary Battery) (See: Battery/Battery
Cable/Negative/Service and Repair).