Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
1. Install the starter motor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the starter motor bolts (1).
Tighten the bolts to 85 Nm (63 lb ft).
3. Install the exhaust manifold-to-catalytic converter pipe. Refer to Catalytic Converter Replacement (LY6 with Exhaust Flange) (See: Engine,
Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement (L9H with Exhaust Flange) (See:
Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement (Gen IV Engines with
Exhaust Clamp) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement
(LFA with Exhaust Clamp) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair)Catalytic Converter
Replacement (LMM) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair).
4. Install the engine wiring harness lead (2) to the starter motor.
5. Install the engine wiring harness lead nut (3).
