Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
Ball Joint: Service and Repair
Lower Control Arm Ball Joint Replacement (2500 , 3500 )
Special Tools
*
CH 41805 - Ball Joint remover/Installer
*
CH 49240 - Ball Joint Crimper and Install Kit
For equivalent regional tools, refer to Special Tools (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Tools
and Equipment).
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
Note: When removing the knuckle, DO NOT remove any of the brake or electrical components from the knuckle. Secure the knuckle assembly to
the side.
2. Remove the knuckle from the vehicle. Refer to Steering Knuckle Replacement (See: Rear Knuckle/Service and Repair).
3. Using a hammer and a chisel, remove the lock tabs (1) from the lower ball joint.
