Silverado 2500 4WD V8-6.6L DSL Turbo (2010)
3. Using the J 37624 - installer (2) and the J 8092 - driver (1), install the inner pinion bearing cup in the pinion gear bearing retainer.
4. Using the J 8608 - installer (2) and the J 8092 - driver (1), install the outer pinion bearing cup in the pinion gear bearing retainer.
Note: Press the bearing on until the cone seats on the pinion.
5. Using the J 24433 - installer and a hydraulic press, install the inner pinion bearing.
6. Install the new collapsible spacer.
7. Lubricate the pinion bearings with axle lubricant. Refer to Fluid and Lubricant Recommendations (USA and Canada) (See: Maintenance).
8. Install the outer pinion bearing into the pinion bearing retainer.
9. Using the J 44414 - installer , install the new pinion oil seal.
